Uploading a Part Design tutorial.

A place to share learning material: written tutorials, videos, etc.
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Post Reply
User avatar
jruiz
Posts: 479
Joined: Tue Oct 28, 2014 1:07 pm
Contact:

Uploading a Part Design tutorial.

Post by jruiz »

Greetings.
I am uploading a tutorial on the Part Design workbench divided into videos of just over five minutes each.
I invite you to take a look at it from my channel

Odysee
or
YouTube

So far I have uploaded ten videos but I plan to continue until I have a more or less complete tutorial on this workbench.

Best regards.
Last edited by jruiz on Tue Jun 15, 2021 12:12 pm, edited 1 time in total.
I have uploaded many FreeCAD video tutorials to my YouTube channel
GeneFC
Veteran
Posts: 5373
Joined: Sat Mar 19, 2016 3:36 pm
Location: Punta Gorda, FL

Re: Uploading a Part Design tutorial.

Post by GeneFC »

The Youtube link is shortened and does not work. You may have copied an abbreviated display instead of the entire link.

Gene
User avatar
jruiz
Posts: 479
Joined: Tue Oct 28, 2014 1:07 pm
Contact:

Re: Uploading a Part Design tutorial.

Post by jruiz »

GeneFC wrote: Mon Jun 14, 2021 3:03 pm The Youtube link is shortened and does not work. You may have copied an abbreviated display instead of the entire link.

Gene
Thanks a lot.
Fixed.
I have uploaded many FreeCAD video tutorials to my YouTube channel
Post Reply