oliveroxtoby wrote: ↑Mon Sep 27, 2021 8:17 pm
Crossleyuk wrote: ↑Thu Sep 23, 2021 3:29 pm
Sorry, finally understood your suggestions and now know how to update the workbench, so that is done for Plot and CfdOF.
Unfortunately, no change niether my own models or your suggested naca2412 finish with
Simulation exited with error
During CfdOF run I receive a red error
? statement "
openfoam: windows support (mingw64) is runtime only"
Regards,
Michael
Hi Michael
You have been following thschrader's advice to re-install blueCFD; however, the error message above suggests you are still using the OpenCFD installation - this is a different Windows packaging of OpenFOAM than blueCFD. So all your reinstallations of blueCFD won't have any effect unless you tell CfdOF to use it. Do this by changing the OpenFOAM installation directory in Preferences to the location where you installed blueCFD, or alternatively, un-install the OpenFOAM installation and leave only the blueCFD one. CfdOF should then automatically use blueCFD if I remember correctly.
You may have missed my reply above. The "windows support us runtime only" error message you mention is not a concern, just a warning printed by the OpenFOAM environment.
It is important to note that there are two different packages of OpenFOAM supported (the ESI/OpenCFD OpenFOAM package, and blueCFD), and you appear to have both installed which is causing confusion. They each come with a specific version of MSMPI and are potentially incompatible with other versions.
I suggest you uninstall both of them, as well as all versions of MSMPI, and then re-do the installation of your preferred package (probably blueCFD, as per the instructions above), making sure to run the installer as administrator and allow it to install MSMPI.
Good luck!