Have you tried changing 'Case Type' on the Properties tab to 'Decomposed Case' (and then clicking apply). This will be necessary if you ran the case in parallel (it is set automatically when paraview is run from CfdOF).Crossleyuk wrote: ↑Thu Oct 10, 2019 11:08 am
So similar results but my observation is that the Properties panel only includes model components and not velocity, pressure etc. properties. And no orientation array options.
10-10-19 PV 5.7.0 Properties Glyph.PNG
I must also repeat that only PV 5.7.0 allows me to open a file to edit without launching it from FreeCAD CfdOF and can’t save anything then.
If that doesn't work, from your version information it looks like you have a pre-release version of Paraview 5.7. Perhaps worth downloading the latest version and trying again.