Hi all,
is it possible to define / execute a simulation of geometry / case where there is no outlet condition ?
E.g. pressure chamber in which fluid flushes in through inlet pipe. The chamber's pressure would rise
during the inflow.
If it is possible coudl you give me short descriotion how to set it up ?
Thx a lot !
Simulation with no outlet
Moderator: oliveroxtoby
Forum rules
and Helpful information for the FEM forum
and Helpful information for the FEM forum
-
- Posts: 114
- Joined: Wed Apr 17, 2019 2:08 pm
- oliveroxtoby
- Posts: 840
- Joined: Fri Dec 23, 2016 9:43 am
- Location: South Africa
Re: Simulation with no outlet
You would need to use a compressible solver, not supported by CfdOF at present.Sidemountyucatan wrote: ↑Tue Jul 23, 2019 1:59 pm Hi all,
is it possible to define / execute a simulation of geometry / case where there is no outlet condition ?
E.g. pressure chamber in which fluid flushes in through inlet pipe. The chamber's pressure would rise
during the inflow.
If it is possible coudl you give me short descriotion how to set it up ?
Thx a lot !
Please provide all the information requested in this post before reporting problems with CfdOF.