Extract from a post in original thread below
https://forum.freecadweb.org/viewtopic. ... 10#p257347
ArchWall based on Sketch with following Shape has problem:-
- A closed wire with multiple edges
- A random edge attach in above edge
- Resulted IFC shape is only a tiny bit as shown
- Without the 'random edge', the IFC seem fine - see next post
Test_ ArchWall_ To_ IFC_ 3c_ Pure Sketch.fcstd
(11.42 KiB) Downloaded 1 time
Test_ Arch Wall _3c_ Pure Sketch_ Linux_ IfcOpenShell_ Python_ 0.17.ifc
(6.42 KiB) Downloaded 1 time
EDIT:
Ifc Export / Viewer Setup
- OS - Fedora 27 64bit
- FC: Appimage - FreeCAD_0.17_13541.9948ee4.glibc2.17-x86_64 (Not really sure if it was this version then)
- IfcOpenShell Python - http://ifcopenshell.org/python.html
- IfcOpenShell Python - not compiled from latest source, just use 'pre-compiled' from above link (same 1 or 2 years not updated)
- Ifc Viewer - Ifc++, compiled from Bernd's repo