problems with IFC import
Re: problems with IFC import
This is a file ifc with only 4 columns e four beams
- Attachments
-
- prova struttura semplice.ifc
- little ifc
- (27.66 KiB) Downloaded 76 times
Re: problems with IFC import
and I also tried another ifc file of implants and in Freecad it is not possible to create the curves of the pipes
- Attachments
-
- opened with an ifc reader
- imp. with BV.JPG (397.52 KiB) Viewed 1478 times
-
- opened with an ifc reader
- imp. with BV 2.JPG (354.1 KiB) Viewed 1478 times
-
- opened with current Freecad 0.18
- imp. with Freecad 0.18.JPG (577.46 KiB) Viewed 1478 times
-
- opened with the aforementioned freecad 0.19
- imp. with Freecad 0.19.JPG (392.86 KiB) Viewed 1478 times
Re: problems with IFC import
would it be possible to post a file with one kurve (which is not imported) between two straight pieces?
Re: problems with IFC import
this is not a file produced by me (while the structural one is made by me), but you can download it from here
http://bim.acca.it/ifc-2x3-coordination-view-2-0/
http://bim.acca.it/ifc-2x3-coordination-view-2-0/
Re: problems with IFC import
my italian is not as good as it should be ... Would you post the direct link to the ifc file?Renato wrote: ↑Wed Feb 19, 2020 11:45 am this is not a file produced by me (while the structural one is made by me), but you can download it from here
http://bim.acca.it/ifc-2x3-coordination-view-2-0/
Re: problems with IFC import
It Is there, in that link, where is written download