In the build file there are some comments talking about FreeCAD
Code: Select all
# *******************************************
# https://forum.freecadweb.org/viewtopic.php?f=4&t=24115&p=232676#p232676
# export LD_LIBRARY_PATH=/usr/local/lib:$LD_LIBRARY_PATH
# be careful, FreeCAD might not run properly, see
# https://forum.freecadweb.org/viewtopic.php?f=4&t=40201
# ATM IFC++ runs without ... so it is deactivated
# printf '\n\nexport LD_LIBRARY_PATH=/usr/local/lib:$LD_LIBRARY_PATH' >> /home/vagrant/.bashrc # libcarve is not found