Thanks, I did as you suggested, but I get exactly the same crash with reference to Numpy as before ... I mean like here: https://forum.freecadweb.org/viewtopic. ... 10#p249524sgrogan wrote: ↑Thu Aug 09, 2018 11:44 pmTry placing the numpy folder in your build with the original from the libpack
I think this is the right one if you replaced the one in the Libpack
https://forum.freecadweb.org/viewtopic. ... 17#p184232
Interestingly, I get a consistent crash with any of the "Example Projects" links, whereas other links on the Start Center Page don't crash.HarryvL wrote: ↑Thu Aug 09, 2018 10:45 pmoh well, I decided to continue and got the Debug version to crash by:
Click "Load an FEM 3D example analysis" in the "Example Projects" box of the "Start Center"
Here are the screen message and the call stack:
Could it have to do with loading NumPy? It is a recurring message.
Thanks Werner, I will try when I have access.wmayer wrote: ↑Fri Aug 10, 2018 7:08 amWhen you are in debug mode can you have a look at the Output panel of Visual Studio. You should get a list of all loaded dlls and I wonder if there might be loaded two different versions of a library.
E.g. netgen links against OCCT and it can happen that FreeCAD is linked against a different OCCT version. This would result in undefined behaviour when FreeCAD loads the FEM module which then pulls the binary incompatible OCCT version.
Thanks @Jee-Bee. This may be related. The thread suddenly stopped on this topic.Jee-Bee wrote: ↑Fri Aug 10, 2018 11:10 amI wanted to give a reaction more early in this thread but din't had the time for it.
Crashing with switching workbenches happens also with the pre-compiled FC.
See: https://forum.freecadweb.org/viewtopic. ... 52#p229652
The stupid thing at least with me is that it isn't consistent. Just sometimes... sometimes 3 or 4 times in a row and then not...
With the pre-compiled version the log is just empty...
Just for your information...
Have you tried renaming the .cfg files in %appdata%/freecad?