WIN 10 0.18 CMAKE configure error - OpenCASCADE not foud

Having trouble installing or compiling FreeCAD? Get help here.
vcfbauplusfe
Posts: 27
Joined: Sat Dec 01, 2018 12:30 pm

Re: WIN 10 0.18 CMAKE configure error - OpenCASCADE not foud

Postby vcfbauplusfe » Fri Dec 07, 2018 7:42 am

Hi @sgrogan,
Hi @all,

did so - realized a complete new CMake run to get the configure and generate
so and explicitly cleaned the CMake cache.

But I will do it again and will recheck the lib bindings in the CMAKE table.

Have a nice day - Volker
vcfbauplusfe
Posts: 27
Joined: Sat Dec 01, 2018 12:30 pm

Re: WIN 10 0.18 CMAKE configure error - OpenCASCADE not foud

Postby vcfbauplusfe » Fri Dec 07, 2018 4:23 pm

Hi @sgrogan,
Hi all,

just for trying to understand the problem:

One of the lib errors was:

55>LINK : fatal error LNK1181: cannot open input file '..\..\..\lib\Release\MEFISTO2.lib'

Did CMake search there for an existing lib and if so where should this lib be located?!?

Or does it complain about a lib it tried to build but wasn't able out of other reasons?

What about the new occ7 and vtk lib you mentioned somewhere - would it be reasonable
trying to link against this new lib?

Thanks for some hints.

Have a good time - Volker