request dwire aligned to active drafting plane

Have some feature requests, feedback, cool stuff to share, or want to know where FreeCAD is going? This is the place.
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
cadgiru
Posts: 82
Joined: Thu Oct 27, 2016 9:53 am
Location: Norway
Contact:

request dwire aligned to active drafting plane

Postby cadgiru » Fri Oct 12, 2018 6:09 am

With reference to post https://forum.freecadweb.org/viewtopic.php?f=3&t=31485
cadgiru wrote:
Thu Oct 11, 2018 5:37 am
Is this a bug?

A dwire created on a plane other then XY, will still have its Normal in global Z direction.

Dropping the dwire to a wire, the resulting wire will have its Normal relative to the plane the dwire was created on.

Resulting in:

Extruding a dwire will always result in an extrusion in global Z direction.

Extruding a wire will extrude in a z-direction normal to plane formed by wire

Consistant repeatable behaviour in fc 0.17 / 0.18

Any ideas anyone?

regards
Hoping we can have a dwire with plane aligned to active drafting plane.

Yes, know there are workarounds, however being able to extrude a dwire directly would speed up modelling.
This is a very efficient way to model, when the overhead of a parametric sketch is not needed.

Q) Why do we have the two entity types wire and dwire. Are they not basically the same?

regards