Minor report: Missing small icon in a field.

[jruiz]

Good morning.
Have you realized that

1. in Part Design WB, when
2. "Make a thick solid" (or "Make a draft on a face") is selected,
3. in the Thickness (or Draft angle) field
4. the little expression icon is missing?

Regards

[chrisb]

Good point. Can you check if there is a ticket in the bug tracker?
If you need it, you can confirm the feature and use the expression in the data tab.

[jruiz]

Good point. Can you check if there is a ticket in the bug tracker?
If you need it, you can confirm the feature and use the expression in the data tab.

Thanks for the information of the data tab.
just reported the tiny little bug.

Regards

[chrisb]

issue #3652
The bug reporting process is: discuss here (done!), create issue (done), crossreference forum and bug tracker (done).

[sgrogan]

issue #3652
The bug reporting process is: discuss here (done!), create issue (done), crossreference forum and bug tracker (done).

Side note: Work around provided(done)