DOF in a sketch

[jpg87]

...

Hi,
In April 2017, I tried a suggestion :
https://forum.freecadweb.org/viewtopic.php?f=3&t=21691
No doubt she was clumsily expressed.
However, I just noted with pleasure that during the construction of a sketch, it is now possible, by clicking on the number of remaining degrees of freedom, to color the entities not yet constrained.
So I come back to my initial idea: Would not it be more appropriate to color constrained entities as the sketch progresses?

[abdullah]

...

Hi,
In April 2017, I tried a suggestion :
https://forum.freecadweb.org/viewtopic.php?f=3&t=21691
No doubt she was clumsily expressed.
However, I just noted with pleasure that during the construction of a sketch, it is now possible, by clicking on the number of remaining degrees of freedom, to color the entities not yet constrained.
So I come back to my initial idea: Would not it be more appropriate to color constrained entities as the sketch progresses?

I did understand you idea. No clumsy at all.

I remember that the answer was: It appears to be the same, but it is a different functionality.

I may revisit that topic again somewhere this year.

[abdullah]

...

Hi,
In April 2017, I tried a suggestion :
https://forum.freecadweb.org/viewtopic.php?f=3&t=21691
No doubt she was clumsily expressed.
However, I just noted with pleasure that during the construction of a sketch, it is now possible, by clicking on the number of remaining degrees of freedom, to color the entities not yet constrained.
So I come back to my initial idea: Would not it be more appropriate to color constrained entities as the sketch progresses?

I did understand you idea. No clumsy at all.

I remember that the answer was: It appears to be the same, but it is a different functionality.

I may revisit that topic again somewhere this year.

P.S.: J'ai compris. Mais, si vous voulais parler avec moi et vous exprimer en Français, vous pouvez faire un "ping" dans le subforum Français. Alors, vous aurez le problème que parfois vous ne comprendrez pas ce que je veux dire, mais restez assuré que je comprendrais ce que vous voulez communiquer

[jpg87]

I may revisit that topic again somewhere this year.

P.S.: J'ai compris. Mais, si vous voulais parler avec moi et vous exprimer en Français, ...

Thank you for your interest in my proposal.
No problem to converse in English: now I'm used to automatic translators!
Anyway, I really appreciate all the improvements you've made to Sketcher WB.