I have a request how to show filenames of macros in the tabs
below is a figure with current behavour
If comparing the FCstd files with FCMacro. from the Macro is the full path visible. Is it possible to make this tha same as the current behavour of the FCstd files?
change request showing macro-names in tabs
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
Be nice to others! Read the FreeCAD code of conduct!
Re: change request showing macro-names in tabs
Shall i make a bugtracker issue?
so that at some point it can be changed?
so that at some point it can be changed?
Re: change request showing macro-names in tabs
There was some discussion recently about tab/window naming, position according to connection between them, ... I think it is better to add a feature request so this will not be forgotten. Maybe short names in tabs and full names as hint?
-
- Veteran
- Posts: 5513
- Joined: Thu Apr 05, 2018 1:53 am