change request showing macro-names in tabs

[Jee-Bee]

I have a request how to show filenames of macros in the tabs

below is a figure with current behavour

2019-07-17 14_37_28-FreeCAD 0.19.png (5.42 KiB) Viewed 773 times

If comparing the FCstd files with FCMacro. from the Macro is the full path visible. Is it possible to make this tha same as the current behavour of the FCstd files?

[Jee-Bee]

Shall i make a bugtracker issue?
so that at some point it can be changed?

[kisolre]

There was some discussion recently about tab/window naming, position according to connection between them, ... I think it is better to add a feature request so this will not be forgotten. Maybe short names in tabs and full names as hint?

[Jee-Bee]

issue #4063

[TheMarkster]

https://github.com/FreeCAD/FreeCAD/pull/2362