[Feature request] : sketcher, adding rectangle by center point

Have some feature requests, feedback, cool stuff to share, or want to know where FreeCAD is going? This is the place.
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
Post Reply
Piero69
Posts: 476
Joined: Thu Jul 04, 2019 1:22 pm
Location: Parma - Italy

[Feature request] : sketcher, adding rectangle by center point

Post by Piero69 »

i feel very useful adding in sketcher the contruction of a rectangle by center point and a corner (so an automatic simmetry)

what do you think?
Top
openBrain
Veteran
Posts: 9041
Joined: Fri Nov 09, 2018 5:38 pm
Contact:
Contact openBrain

Re: [Feature request] : sketcher, adding rectangle by center point

Post by openBrain »

Same feature request was done some days ago.
Top
Piero69
Posts: 476
Joined: Thu Jul 04, 2019 1:22 pm
Location: Parma - Italy

Re: [Feature request] : sketcher, adding rectangle by center point

Post by Piero69 »

openBrain wrote: ↑Fri Feb 07, 2020 9:07 am Same feature request was done some days ago.
Sorry i didn't see it ...

openbrain how can i see if a "feature request" has been promoted as "new feature under development" and its progress?

it's nice to have an official list for the new features under development, the progress state and when released
Top
mario52
Veteran
Posts: 4692
Joined: Wed May 16, 2012 2:13 pm

Re: [Feature request] : sketcher, adding rectangle by center point

Post by mario52 »

hi

Sketcher_Micro_Tutorial_-_Constraint_Practices

Image

mario
Maybe you need a special feature, go into Macros_recipes and Code_snippets, Topological_data_scripting.
My macros on Gist.github here complete macros Wiki and forum.
Top
Post Reply

Return to “Open discussion”