FreeCADHi, anyone working on surface to surface tangency with the intent of up-streaming it to master?
The surfaces shall have a common curve ruling them both.
https://www.bitchute.com/video/m9v0koWe7f14/Pauvres_honteux wrote: ↑Wed May 27, 2020 1:46 pmHi, anyone working on surface to surface tangency with the intent of up-streaming it to master?
The surfaces shall have a common curve ruling them both.
Hi, sorry to say but the problem still persist: there's still no way to define a start and end surface tangency for a multi section surface, where everything stays connected. And I have yet to see any solution to it, with the exception of Thomas
but he doesn't seam to be interested in upstreaming it to master...
for a very simple real life turbo inlet tube.
would give some clues?realthunder wrote:
Hi gAdlike, you seem to be programming for the OCE-project?gAdlike wrote:
Hi Kunda1, it seams as gAdlike isn't around any more. Do you have suggestions on other people programming for OCE/OCCT ?Kunda1 wrote:
Not sure, maybe yorik or kkremitzki might know ?Pauvres_honteux wrote: ↑Sun May 31, 2020 8:31 amHi Kunda1, it seams as gAdlike isn't around any more. Do you have suggestions on other people programming for OCC/OCCT ?
yorik wrote:
kkremitzki wrote:
.wmayer wrote:
Anyone? 