svobodat59 wrote: ↑
Wed Aug 26, 2020 7:11 pm
Is there any way in the Fasteners settings to influence this ?
Indeed there is, as chrisb mentioned already before: select the fastener workbench, goto Edit -> preferences. Select Fasteners on the left. In the fastener settings there is a "Tread generation" option. If you select "3D printer compatible", all fasteners will have a dimension compensation for 3d printing. The default parameters are a good start, but you might want to tweak them based on your printer and filament.
It is important to note that if you already generated some threads, they will not be affected by the new settings until you recompute them.