BUG: Wire is not closed (but it should be closed)

Have some feature requests, feedback, cool stuff to share, or want to know where FreeCAD is going? This is the place.
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
Post Reply
marioalexis
Posts: 124
Joined: Wed Jun 19, 2019 7:44 pm

Re: BUG: Wire is not closed (but it should be closed)

Post by marioalexis »

See this pull request: https://github.com/FreeCAD/FreeCAD/pull/4100
The normal of Edge001 (Mirror #2) should be corrected to allow the creation of flat wires.
Top
Post Reply

Return to “Open discussion”