under Part workbench, we have two tools: 3D and 2D offset.
https://wiki.freecadweb.org/Part_CompOffsetTools
why not to put them under a common menu Offset?
Part -> Offset -> 2D offset and 3D offset.
GUI under Part, 3D and 2D offset under a same menu
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
Be nice to others! Read the FreeCAD code of conduct!
Re: GUI under Part, 3D and 2D offset under a same menu
Geez, seems that the way I have it...
amazing what you can do to customize your by using the Tools>Customize
amazing what you can do to customize your by using the Tools>Customize
Star Trek II: The Wrath of Khan: Spock: "...His pattern indicates two-dimensional thinking."
Re: GUI under Part, 3D and 2D offset under a same menu
thanks for the capability to customize.
it's a bit puzzling because we have button on the GUI collecting the two options, so why not to extend this to the menu?
and it will be helpfull too for the wiki.
it's a bit puzzling because we have button on the GUI collecting the two options, so why not to extend this to the menu?
and it will be helpfull too for the wiki.
Re: GUI under Part, 3D and 2D offset under a same menu
You mean from the Part menu?
Star Trek II: The Wrath of Khan: Spock: "...His pattern indicates two-dimensional thinking."
Re: GUI under Part, 3D and 2D offset under a same menu
I mean the GUI is already doing it
my initial post was showing a mock-up.
why not the menu?my initial post was showing a mock-up.