[Features Requests] Point on B-spline edge and spline trimming

Have some feature requests, feedback, cool stuff to share, or want to know where FreeCAD is going? This is the place.
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
Post Reply
Yosyp
Posts: 39
Joined: Mon Jul 19, 2021 10:48 am
Contact:
Contact Yosyp

[Features Requests] Point on B-spline edge and spline trimming

Post by Yosyp »

Image

I guess the picture is self explanatory.
I also need to pad only a section of the exported geometry, but currently I can't trim the B-spline cause I have no point to do so.
Last edited by Kunda1 on Mon Jul 19, 2021 11:29 am, edited 1 time in total.
Reason: put image in bbcode
Top
chrisb
Veteran
Posts: 54302
Joined: Tue Mar 17, 2015 9:14 am

Re: [Features Requests] Point on B-spline edge and spline trimming

Post by chrisb »

Yosyp wrote: ↑Mon Jul 19, 2021 10:51 am I guess the picture is self explanatory.
And so is the message. Point-on-B-spline isn't implemented yet. You may look at the document in my signature to learn about B-splines in Sketcher.
A Sketcher Lecture with in-depth information is available in English, auf Deutsch, en français, en español.
Top
Post Reply

Return to “Open discussion”