Hi,
Is it possible to make line based on length+angle. I know that Draft has ability to create points relative to the last placed vertex. I do not know, but I think that it should not be hard to implement length-angle based lines placement. At least it seems trivial on top view (XY plane) to implement this, but it will probably be harder to do it on a working plane. What do you think about it?
Regards
Petar Perisin
Line form length+angle (in Draft)
Forum rules
Be nice to others! Read the FreeCAD code of conduct!
Be nice to others! Read the FreeCAD code of conduct!
Re: Line form length+angle (in Draft)
Hm I think it should not be too hard to do, even on a working plane. I'll add this to my todo list...