Hi Pablo.pablogil wrote:Is it a "not yet done" project?
You're welcome.pablogil wrote:Thanks for the update
Well if the users would like for the Selector toolbar to be upstreamed it can happen. Translations support and making the workbench change experience from current good to possible perfect would likely need to be achieved first. As if user for example uses workbench switcher instead of Selector toolbar and pay close attention Selector toolbar buttons flickers slightly on workbench change. The way FreeCAD manages adding toolbar commands to toolbars would therefore need to be extended and upstreamed Selector toolbar version adapted.pablogil wrote:I have just tried it and I like it, IMHO it's a must have, it should be added to FreeCAD master... after a few tweaks
Yes this is a bit inconvenient. As i updated the Icon themes module when i made the Selector toolbar release. But the user still needs to pull the changes for them to take effect.In macOS I have installed iconThemes and now Selector and when navigating to the preferences I find two different "Accessories" entries:
I am interested in fine tuning the user experience based on the reasonable user suggestions. Optional selector menu button therefore should use the same icon all the time and shouldn't adapt to workbench and button style changes?And till now I haven't realized an UX improvement I think it will make Selector much better: If you enable the Front/End menu which list all the workbenches installed (very cool option) you end up with two "tabs" with the same name, the actual workbench and the menu button which also shows the actual workbench... it is redundant...
I would suggest to show it like the following (they are just sketches to make you understand what I'm following):
What do you think about it?
You're welcome.In any case, thank you very much, Selector will make my life easier
Yes, I think using the same icon for representing the menu button to list the full bunch of workbenches installed would be easier to understand and locate (and also unique in the way that no other icon would be similar to the one used to list the workbenches)triplus wrote:I am interested in fine tuning the user experience based on the reasonable user suggestions. Optional selector menu button therefore should use the same icon all the time and shouldn't adapt to workbench and button style changes?