Huhu, schön.
Leider kann ich die Zip's nicht entzippen:
Hallo Gift,
When I was reading this, I was thinking "what about if we would use the surface made by the three horizontal line sketches to do this parting plane...", right in your the next post I saw the result of it, nicefreecad-heini-1 wrote: ↑Sat Sep 30, 2017 7:31 am I cloned the new curve again and scaled it up with factor 2. Between the two curves I created a ruled surface. The result looks good. That is a nice parting plane. The trick with scaling the outer curce is better than the ProE trick with projection to a cylinder surface.
True, it would maybe be good to have another sample where the fillet would have an variable radius, that should flex our brains and tools a bit morefreecad-heini-1 wrote: ↑Sat Sep 30, 2017 7:31 am But this is a really easy model. I created it to explain the subject. Mostly plastic parts are more complex, with rounds and bevel of mold.
Shape2dview must be more precice as well as section.
Sehr gut Thomas. Wunderbar welche fähigen Leute hier versammelt sind.microelly2 wrote: ↑Mon Oct 02, 2017 8:21 pm Ich habe mal den ersten Prototypen eines Skriptes, der diese Schnittflächen berechnet.
bp_579.png
Es braucht noch die Feinarbeit, aber so könnte man das hinbekommen.
Alle Punkte berechnen, bei denen der Flächennormalenvektor horizontal ist. Davon die Kurven und dann die Normalenrichtung drauf.
Ohha , darauf habe ich nicht geachtet.thschrader wrote: ↑Tue Oct 03, 2017 8:20 am Hallo Gift,
danke für die Bilder (zip konnte ich auch nicht öffnen).
Mittlerweile meine ich zu verstehen, worauf Wilfried hinaus will.
Wenn man das Fugendetail vergrößert, sieht man das die untere Form etwas um
das Bauteil herumgreift, d.h. nach dem pressen kann man es nicht aus der Form lösen.
Der Ausgangspunkt der Trennfuge müsste etwas tiefer liegen (dort wo microelly die
Normalenvektoren platziert, siehe Bild oben).
Gruss Thomas
fuge.JPG
Ich zippe eigentlich nur damit ich Datei anhängen kann. Mein Browser ist da eigenwillig.
Aus Kostengründen sollte sie aber unbedingt aus so wenigen Teileinsätzen wie möglich bestehen.thschrader wrote: ↑Wed Oct 04, 2017 11:33 amMal ehrlich: ich auch nicht!
aber die Pressform muss ja nicht nur aus 2 Teilen bestehen...