Basic Part Design Tutorial

[HarryGeier]

Well, he can create a page on the wiki, and add his tutorial..

If he wants, he can pass it over to me and i can add it to the wiki ..

[jpg87]

Hi, i go over it tomorrow..

Hi Harry,
thanks for the changes.
I tried to modify by adding the <translate> tags, but as it did not seem to work, I canceled my changes. I discovered today in another thread that the changes are not instantaneous. Everything is in order.

Well, he can create a page on the wiki, and add his tutorial..

If he wants, he can pass it over to me and i can add it to the wiki ..

I have not created any pages in the wiki yet, but I agree to try.

[NormandC]

As I wrote previously, it could be added as a section at the end.

We already have two nearly identical tutorials on the wiki, one for 0.16 and the other for 0.17. I would prefer we not add a third about the exact same part.

[HarryGeier]

As I wrote previously, it could be added as a section at the end.

We already have two nearly identical tutorials on the wiki, one for 0.16 and the other for 0.17. I would prefer we not add a third about the exact same part.

i understood it´s something different.. if it´s the same part.. we would only confuse. We already discussed and it was the common sense to show the same way of construction as in 0.16 for that part, just rework for .17. , leaving away all new stuff ( datum geo, shapebinder, tip setting etc....)
I also still have my .16 .-> .17 differences Tutorial in the box which i want to add.

So, can you explain what your tutorial is about ??