I am thinking now that I should have deleted the extra refine pockets that are causing the red arrows in Dependency Graph.
Then delete the pocket that was not showing in the model
then redo the pocket.
Hopefully this will make a clean Dependency Graph.
Just redid the refine shape operation and it came out outside the body. Following bejant's advice before, I think this means to create a second body.
So far I don't know how to get the refine shape into the first body. Creating a 2nd body only creates a new dependency graph next to the first one.
bejant wrote: ↑
Fri Jun 29, 2018 8:03 pm
The two different ways to model a Switch Base shouldn't be difficult because the Switch Base is a single piece. If you start the model by creating your very first Sketch while you are in the Part Design WB, a Body should automatically be created and made active before you are taken to the Sketcher WB.