Split Artwork and Artwork Guidelines

Discussions about the wiki documentation of FreeCAD and its translation.
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Post Reply
User avatar
wandererfan
Veteran
Posts: 6270
Joined: Tue Nov 06, 2012 5:42 pm
Contact:

Split Artwork and Artwork Guidelines

Post by wandererfan »

@agryson's icon styling guidelines were tacked on to the end of the Artwork page. I got tired of waiting for Artwork to load completely before I could see the guidelines, so I've split them off in to a separate Artwork_Guidelines page.

If there are objections, I'll put it back the way it was.
triplus
Veteran
Posts: 9471
Joined: Mon Dec 12, 2011 4:45 pm

Re: Split Artwork and Artwork Guidelines

Post by triplus »

Likely that is how it should be done from the beginning. Thanks for tackling this.
User avatar
bejant
Veteran
Posts: 6075
Joined: Thu Jul 11, 2013 3:06 pm

Re: Split Artwork and Artwork Guidelines

Post by bejant »

It can take an annoyingly long time for that Artwork page to load. It might also be a good idea to have separate wiki pages, one page for shared icons (View icons for example) and other wiki pages by WBs (one wiki artwork page per WB). The original Artwork page could remain a mega repository of for all the icons just so that they are all in one place.
renatorivo
Veteran
Posts: 2611
Joined: Tue Feb 21, 2012 8:07 pm
Location: Torino - Italy

Re: Split Artwork and Artwork Guidelines

Post by renatorivo »

There are already pages with WB icons, but they are not updated. Perhaps they must be changed.
See for example
https://www.freecadweb.org/wiki/Arch_Key
https://www.freecadweb.org/wiki/Arch_Icon
Le_Loup
Posts: 20
Joined: Sun Apr 08, 2018 10:00 am

Re: Split Artwork and Artwork Guidelines

Post by Le_Loup »

The two pages should now be closer to v0.16...
Le_Loup
Posts: 20
Joined: Sun Apr 08, 2018 10:00 am

Re: Split Artwork and Artwork Guidelines

Post by Le_Loup »

In https://www.freecadweb.org/wiki/Workbench_ICON the icon of "Draft UndoLine" looks like the one of "Draft Rotate". In FreeCAD instead of "Undo Line" I could only find "Toggle Continue Mode" so it seems that "Undo Line" is deprecated?
Post Reply