Thank you...
I think it should be integrated as an horizontal feature for all workbenches, as suggested by pablogil.
igmar
- start FreeCAD
what is an horizontal feature ?
But the shape or the mesh are hollow inside.i.e. the appearance is not solid.bernd wrote: ↑Sun Oct 07, 2018 8:52 pm- start FreeCAD
- open schenkel.stp
- change to FEM workbench
- select a face of a shape
- click on icon "Add clipping plane on selected face"
- select the long small box to move the clipping plane
- select one of the 6 cubes to zoom the clipping plane icon
- select the slab wireframe box to move the clipping plane icon
- select one of lines between the cubes and the wireframe box to change the clipping plane angle
- you can add as much clipping plane as you want, but only one by one, not more than one at once
My post folloed on this post, but my one was refering to the post of howil.
+1000freecad-heini-1 wrote: ↑Mon Oct 08, 2018 10:31 amI would like to see something like this:
For Part and PartDesign and other pobular Workbenches.
https://forum.freecadweb.org/viewtopic. ... 90#p241390