OS: Linux Mint 19 Tara
Word size of OS: 64-bit
Word size of FreeCAD: 64-bit
Version: 0.18.14995 (Git) AppImage
Build type: Release
Python version: 2.7.6
Qt version: 4.8.6
Coin version: 4.0.0a
OCC version: 7.3.0
Locale: English/UnitedKingdom (en_GB)
i am trying to engrave some lines on a plate but can't figure it out, see attached file. If I have SketchEngraveLines under the body, as shown, I cannot see the lines to add them as the base geometry for the engrave operation. If I move it to the same level as Body I can see the lines but still cannot add them to the Base Geometry. I have used Map Sketch to Face in Part Design
Also SketchEngraveLines shows an error marker, Error, Internal name: Sketch001 - that was the original name. Is that relevant?
What am I doing wrong?
- (17.67 KiB) Downloaded 40 times