Hi @sgrogan,
Hi @all,
did so - realized a complete new CMake run to get the configure and generate
so and explicitly cleaned the CMake cache.
But I will do it again and will recheck the lib bindings in the CMAKE table.
Have a nice day - Volker
WIN 10 0.18 CMAKE configure error - OpenCASCADE not foud
Forum rules
Be nice to others! Respect the FreeCAD code of conduct!
Be nice to others! Respect the FreeCAD code of conduct!
-
- Posts: 27
- Joined: Sat Dec 01, 2018 12:30 pm
-
- Posts: 27
- Joined: Sat Dec 01, 2018 12:30 pm
Re: WIN 10 0.18 CMAKE configure error - OpenCASCADE not foud
Hi @sgrogan,
Hi all,
just for trying to understand the problem:
One of the lib errors was:
55>LINK : fatal error LNK1181: cannot open input file '..\..\..\lib\Release\MEFISTO2.lib'
Did CMake search there for an existing lib and if so where should this lib be located?!?
Or does it complain about a lib it tried to build but wasn't able out of other reasons?
What about the new occ7 and vtk lib you mentioned somewhere - would it be reasonable
trying to link against this new lib?
Thanks for some hints.
Have a good time - Volker
Hi all,
just for trying to understand the problem:
One of the lib errors was:
55>LINK : fatal error LNK1181: cannot open input file '..\..\..\lib\Release\MEFISTO2.lib'
Did CMake search there for an existing lib and if so where should this lib be located?!?
Or does it complain about a lib it tried to build but wasn't able out of other reasons?
What about the new occ7 and vtk lib you mentioned somewhere - would it be reasonable
trying to link against this new lib?
Thanks for some hints.
Have a good time - Volker