Hello,
Is there any macros or patches to calculate for example the mass flow rate ?
How do you proceed ?
Sorry but i have very few experience with openfoam
Best regards
Moderator: oliveroxtoby
You are using the His solver for pipe flow with 0,5 m/s inlet speed.
Not from scratch. I will have a look at it.julieng wrote: ↑Fri Dec 21, 2018 5:26 amHello
Do you know how to plot the drag and lift forces on function of time with paraview?
I do the same steps extract surface, generate normals, calculate pressure x normal x Rho.
If i try integrate variable and plot other time i have nothing in my graph.
Best regards