Hi everyone!
I'm new to this forum. I'm an engineer



My job is to create engineering drawings for different couches. Some are single, some are double, some have headrests, etc. (See pic below).

All together, I have maybe 6 combinations. Those 6 combinations will always look the same, except for 9 key dimensions (length, width, height of each cushion). When I deliver these drawings to a customer, it may be for multiple types of couches (e.g. a single and a double).
I need an efficient set-up that allows me to:
- Change the key dimensions on a part, have it auto-change in the drawing
- Have the drawing include all the different couch types that were ordered (so like 1 page for a single couch, 1 page for a double couch, etc.
- Change the material callouts for each cushion
- Add a table with material list and part numbers
- Modify drawing notes


Thanks!