meme2704 wrote: ↑
Wed Jan 23, 2019 4:13 pm
How do you want the extrusion to work with an open sketch
Why make a B-spline when a radius is enough and more saft
At home, a 1.5mm net works
I know it can't work with open sketch, that's the purpose of my question, is there a way to close an open sketch once we find there some open end on something already drawn? But I think I finally got it with the coincident constraint. See my reply to openBrain below.
I tried that but at first it was not working. Now I got it. I was trying to use the coincident constraint while I had angles constrain on the corner of my lines. So the coincident constraint was not working. I had to remove the angle contraints in order to do the coincident constraint! I will get there!
But now I'm still strugling with the fillet. I need to do a fillet on the front part of the lever (green line on the picture) and I have not succeeded yet. Or maybe there's another way than fillet to do it?
Better you provide the FCstd file and tell us what fillet radius you would use. So we can figure out what's going wrong.
Right now the radius is not very important, I just want to be able to do it on the edges I mention earlier. See the attached FCstd and my previous picture a few lines above.
Stou wrote: ↑
Tue Jan 22, 2019 10:44 pm
Ok, thanks for the constrain info. I'm starting to be more comfortable with the constrain. It look like a mess but it is full contrain.
Yes a little bit