Plotting of Concrete Reinforcement Ratio
Moderator: bernd
Forum rules
and Helpful information for the FEM forum
and Helpful information for the FEM forum
Re: Plotting of Concrete Reinforcement Ratio
I have to admit that I am not entirely sure how to make a”unit test”
Re: Plotting of Concrete Reinforcement Ratio
https://github.com/berndhahnebach/FreeC ... #L245-L266 and the comments in https://github.com/FreeCAD/FreeCAD/blob ... TestFem.py
if you only would like to run the pricipal stress unit test just do a
Code: Select all
./bin/FreeCAD --run-test "femtest.testresult.TestResult.test_stress_principal"
Code: Select all
make -j4 && ./bin/FreeCAD --run-test "femtest.testresult.TestResult.test_stress_principal"
Re: Plotting of Concrete Reinforcement Ratio
@bernd will there be any further development of the mixed mesh capability?bernd wrote: ↑Tue May 22, 2018 8:13 pm+1 and +1HarryvL wrote: ↑Tue May 22, 2018 7:23 pm1) Maybe we should try square x-section rather than round. The shape doesn't matter too much. It's just a way to introduce an internal load.
2) We could try mixed meshes once it can handle embedding 1D or 2D elements in 3D. It would be ideal to model the cable as a string of 1D elements. Or even a 2 D strip would be a great simplification.