Boneshaker wrote: ↑Mon May 20, 2019 3:09 pm
I was curious about your way of modelling this.
I haven't finished but here's where I left off. The .pdf
lists shows the Spreadsheet cells
near the corresponding dimension but it is incomplete, it was done before I knew how the finished model was supposed to look, and if I were to do it again I'd only reference a few values from a Spreadsheet (as it is now I think it is more confusing than practical).
OS: Ubuntu 18.04.2 LTS
Word size of OS: 32-bit
Word size of FreeCAD: 32-bit
Version: 0.18.1.
Build type: Release
Python version: 3.6.7
Qt version: 5.9.5
Coin version: 4.0.0a
OCC version: 7.3.0
Locale: English/UnitedStates (en_US)
blue and strike-through = edit for better wording.