Hi sliptonic,
Here a new test with fremans part, i try to get the pathes like i would do if i want to mill out the part.
First the center hole: select wall of hole, use Poket OP, - works like expected
Countersinc hole: select bottom of hole, use Poket OP, - works like expected
Surface near uper box: select the top faces, use Pocket OP - works like expected
Surface near zylinder: select the top faces, use Pocket OP - works like expected
For removing remaining material near the corners i use countur ops next
Select upper edges of upper box, use Contour by edges OP, - pre / automatic selection of depht sets wrong values
Select upper face of upper box, use Contour by facees OP, - pre / automatic selection of depht sets wrong values
Sitting the right dephts manuel works
Same behavior at creating the path around the cyllinder.
Next step: selecting upper face, use MillFace OP, - works like expected.
Last step: use Contour OP, pre / automatic selection of depht sets wrong values, after setting the true values for dephts and clicking Apply or OK, FC freases, if i wait long, the whole system freezes.
Behavior at
OS: openSUSE Leap 15.1
Word size of OS: 64-bit
Word size of FreeCAD: 64-bit
Version: 0.18.Unknown
Build type: Release
Python version: 3.6.5
Qt version: 5.9.7
Coin version: 3.1.3
OCC version: 7.3.0
Locale: German/Germany (de_DE)
If i do the same at
OS: openSUSE Leap 15.1 (KDE//usr/share/xsessions/plasma5)
Word size of OS: 64-bit
Word size of FreeCAD: 64-bit
Version: 0.19.16822 (Git) AppImage
Build type: Release
Branch: master
Hash: 243aebf2dfbfe192b5bbd067020a5318a0fa8d0d
Python version: 3.7.1
Qt version: 5.6.2
Coin version: 4.0.0a
OCC version: 7.3.0
Locale: German/Germany (de_DE)
the pre / automatic selection of depht at Contour OPs works, but puts in a critical value for the final depht. Clicking Apply or OK changes the depht values to a different but not to the part fitting value. (the upper level of the part is at 0, all other levels are -x values)
Trying to create a Contour path results also in a freezing of FC.