Russ4262 wrote: ↑Wed Aug 28, 2019 8:22 pm
In such a case the user should verify the depth set for the pocket.
Russell
It is OK to verify. But after it is verified, it becomes to be unnecessary.
And something more about it: sometimes pocket will become a hole after reversing a stock and facing other side.
In this case depth of a pocket is always bigger than a faces used.
So, sometimes it will be nice to obtain pocket's path not from faces, but from edges on upper face.
For now it is prohibited option.
Russ4262 wrote: ↑Wed Aug 28, 2019 8:22 pm
Cursor will continually spin until the 'OK' button is clicked.
Russell
Nope. Spinning cursor is not allowing to click the button. Only Alt+F4 helps.
Is it modal?
No need for apologies, Russell. It part of job, you see.
Sincerely,
Eugenijus.