- DBSnSFB2FB01.png (195.28 KiB) Viewed 475 times
Is it possible to Loft/Sweep Facebinders?
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
Is it possible to Loft/Sweep Facebinders?
Is it possible to Loft or Sweep these Facebinders to make them into a singular solid shape?
The program wouldn't perform the function with these objects, but I am wondering if there is a similar way to enact the same procedure with a different tool or function.
-
papyblaise
- Veteran
- Posts: 8000
- Joined: Thu Jun 13, 2019 4:28 pm
- Location: France
Re: Is it possible to Loft/Sweep Facebinders?
Hello again
fuse upper and lower and do chanfer , (I can't stop myself and I do sharp on the blade too
)
fuse upper and lower and do chanfer , (I can't stop myself and I do sharp on the blade too
)- Attachments
-
- tip sword.PNG (44.57 KiB) Viewed 467 times
-
- sword.FCStd
- (85.06 KiB) Downloaded 17 times
Re: Is it possible to Loft/Sweep Facebinders?
Jello papyblaise.
The technique you showed me above gave me an idea for how to solve the problem:
Thank you for the inspiration and solution.
This is fairly close to the final appearance of the sword, now I just have to finish the fuel line and trim down the upper blade base.
The upper blade base is just a decorative line across the sword, it was never meant to be a cutting edge.
The technique you showed me above gave me an idea for how to solve the problem:
- DBSnSwordCf01.png (220.41 KiB) Viewed 450 times
This is fairly close to the final appearance of the sword, now I just have to finish the fuel line and trim down the upper blade base.
The upper blade base is just a decorative line across the sword, it was never meant to be a cutting edge.