Dear Community,
first of all -> Hello and thank you for all the efforts concerning this great software.
I'm slowly getting used to FreeCAD but what i truly do not understand is how to move multiple points in Sketch mode. Or is there a better way than sketching?
Video of my problem: https://puca.biz/freecad_dragging.mp4
Thank you
OS: Mac OS X
Word size of OS: 64-bit
Word size of FreeCAD: 64-bit
Version: 0.17.7427 (Git)
Build type: Release
Branch: (detached from c56dfa2)
Hash: c56dfa254cbbfa053d3ecf5a88cdcf88a15f1be6
Python version: 2.7.11
Qt version: 4.8.7
Coin version: 3.1.3
OCC version: 6.8.0.oce-0.17
How to drag / move multiple points in sketch?
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
- DeepSOIC
- Veteran
- Posts: 7896
- Joined: Fri Aug 29, 2014 12:45 am
- Location: used to be Saint-Petersburg, Russia
Re: How to drag / move multiple points in sketch?
Hi!
There is no direct way of moving multiple points in sketcher (it was asked before, but no one bothered to implement it AFAIK). However, there are a few hacks.
1. Moving a line is equivalent to dragging its endpoints simultaneously
2. you can set up temporary constraints to drag the wanted points together. Convoluted, but can help in some situations.
3. Try cloning the whole geometry. The cloning interface allows you to put the result where you need.
There is no direct way of moving multiple points in sketcher (it was asked before, but no one bothered to implement it AFAIK). However, there are a few hacks.
1. Moving a line is equivalent to dragging its endpoints simultaneously
2. you can set up temporary constraints to drag the wanted points together. Convoluted, but can help in some situations.
3. Try cloning the whole geometry. The cloning interface allows you to put the result where you need.
Re: How to drag / move multiple points in sketch?
Thank you, i will open a feature request on that