G-code for rounded edges

Here's the place for discussion related to CAM/CNC and the development of the Path module.
m0n5t3r
Posts: 104
Joined: Fri Feb 03, 2017 2:55 pm

Re: G-code for rounded edges

Postby m0n5t3r » Thu Feb 27, 2020 11:17 am

Looks like you don't have opencamlib

If you're proficient with the command line there is an opencamlib deb package source here: https://salsa.debian.org/m0n5t3r-guest/opencamlib (I was asked to submit a merge request, did it, no response so far, I guess kkremitzki is a lot busier than me)

You can clone it, install build dependencies and run

Code: Select all

fakeroot debian/rules binary
which will build a python3-opencamlib deb package - I tested this in a debian unstable container before sending the merge request, should work in buster too.

I'm not sure the appimage thing can use it, though (never used it, if it's something along the lines of snap and flatpak it will have its own container-like isolation environment and won't be able to use the system python libraries).