What is the approach that I should follow to punch a series of shaped holes through a sphere e.g. trying to achieve the top part of this rattle.
Creating repeated holes through a sphere
Forum rules
and Helpful information
and Helpful information
IMPORTANT: Please click here and read this first, before asking for help
Also, be nice to others! Read the FreeCAD code of conduct!
Also, be nice to others! Read the FreeCAD code of conduct!
-
- Posts: 29
- Joined: Sun May 10, 2020 7:27 am
- Location: Scotland
Re: Creating repeated holes through a sphere
Set up a few Datum Planes at the correct place and angle.
Draw sketches of the apertures and pocket through the hollow hemisphere.
A polar pattern for each pocket.
Add in some guessing for hole shape and position.
Draw sketches of the apertures and pocket through the hollow hemisphere.
A polar pattern for each pocket.
Add in some guessing for hole shape and position.
- Attachments
-
- Rattle Top.png (53.46 KiB) Viewed 1077 times
Re: Creating repeated holes through a sphere
Awesome, thanksReynard1066 wrote: ↑Mon Jul 06, 2020 1:24 pm Set up a few Datum Planes at the correct place and angle.
Draw sketches of the apertures and pocket through the hollow hemisphere.
A polar pattern for each pocket.
Add in some guessing for hole shape and position.
Re: Creating repeated holes through a sphere
I am battling to place the Datum planes. Could you please give me a screenshot of your Plane Parameter settings so that I can compare?
I tried adding a datum plane and then move it 40mm along the y-axis but nothing happens
I tried adding a datum plane and then move it 40mm along the y-axis but nothing happens
- Attachments
-
- Rattle.FCStd
- (8.49 KiB) Downloaded 29 times
Re: Creating repeated holes through a sphere
The coordinates are local to the attachment, so you may have to move the X or Z coordinates instead of the Y coordinate.
Always add the important information to your posts if you need help. Also see Tutorials and Video tutorials.
To support the documentation effort, and code development, your donation is appreciated: liberapay.com/FreeCAD.
To support the documentation effort, and code development, your donation is appreciated: liberapay.com/FreeCAD.
-
- Posts: 29
- Joined: Sun May 10, 2020 7:27 am
- Location: Scotland
Re: Creating repeated holes through a sphere
Yes datum planes do seem like trial and error to see which way they move, but you work something out eventually.
I have been struggling to get the file size below the 1Mb mark. Using compression level 9 seemed to do it.
File attached.
I have been struggling to get the file size below the 1Mb mark. Using compression level 9 seemed to do it.
File attached.
- Attachments
-
- Rattle Top.FCStd
- (982.14 KiB) Downloaded 57 times