Not sure if this has been discussed before.
At least a search on the Bug Tracker turned up with no results.
I would like to have two features added to the sketcher:
- Like the "Trim Edge"-Tool I would like to have and "Extend to Line"-Tool.
You select the line to serve as boundary, you select the "Extend to Line"-Tool and click on a line to be extended
until it reaches the boundary line. Throws an error when not possible.
- Like the "Fillet Edge"-Tool I would like to have a "Chamfer Edge"-Tool. Chamfer could be defined by length and angle
or by two lengths or like the "Fillet Edge"-Tool by clicking at two points.