Shouldn't the tool tip to Pad say Pad a selected Sketch or Face ?

A forum for research and development of the user interface of FreeCAD

Moderator: agryson

Post Reply
FredOP
Posts: 51
Joined: Sat Sep 26, 2020 1:25 pm

Shouldn't the tool tip to Pad say Pad a selected Sketch or Face ?

Post by FredOP » Wed Oct 21, 2020 11:17 pm

In Part Design WB, I randomly discovered that Pad has the ability to extrude faces directly.
Everything in the UI seems to completely ignore this ability, whether the text of the tool tip or its absence in the Tasks panel when a face is selected.
Same for revolve, loft, sweep.

Post Reply