Page 2 of 2

Re: Assembly Workbench icons aligned to guidelines

Posted: Sun Mar 19, 2017 9:19 pm
by agryson

Re: Assembly Workbench icons aligned to guidelines

Posted: Mon Mar 20, 2017 1:02 am
by triplus
agryson wrote:Done.
Thanks for the tip on implementation @triplus

This can now be in the pull request. (tested sucessfully on local)

AssemblyWorkbench.svg
You're welcome. I guess what we now need is a bit more useful Assembly workbench. ;)

P.S. Or maybe after you finish all the work you might give it a shot at aligning Assembly 2 workbench icons. As that is more or less what FreeCAD users have been using in the past years when it comes to Assembly capabilities. Note that this is just an idea and feel free to disregard it.

Re: Assembly Workbench icons aligned to guidelines

Posted: Mon Mar 20, 2017 5:57 am
by agryson
triplus wrote:maybe after you finish all the work you might give it a shot at aligning Assembly 2 workbench icons. As that is more or less what FreeCAD users have been using in the past years
sounds good, and I'm sure that many of the icons could be reused between the two during development of FreeCAD Assembly. added to the list