FreeCAD Forum

Thanks It won't be part of the official release. Because FreeCAD and modern UI have different licenses. Its available as add-on only.

About workflow.

From part desingn I can select a sketch and click to "edit selected sketch" icon.
Then I need to go to sketcher and I can edit the sketch, tnen click to "close edit sketch" icon and go back to part design workbench.
It can be improver with open automatic sketch workbench when click to edit sketch icon and go back to previous workbench when click to close edit sketch icon.

I think it's not possible for modern UI.

Is it possible to load a user WB as a tab when starting and show that tab?

Also give a Macro tab.

If you asking for an external wb yes it automaticly add it

johnwang wrote: ↑Tue May 12, 2020 11:23 am Also give a Macro tab.

Macro tab? I didn't understand what you mean.

Like your Trails WB, Could you give it a Tab and when FC is open, it is shown up (selected, current Tab) ready to use. No need to manually switch?

Edit:
Just dropped my WB under the Mod folder, Modern Setting listed it and checked, but no Tab show up.

HakanSeven12 wrote: ↑Tue May 12, 2020 11:28 am Macro tab? I didn't understand what you mean.

The 4 macro buttons under a normal TAB. Not just under your Modern UI tab.

johnwang wrote: ↑Tue May 12, 2020 11:31 am Edit:
Just dropped my WB under the Mod folder, Modern Setting listed it and checked, but no Tab show up.

Uncheck it. Restart. Check again. Restart.

johnwang wrote: ↑Tue May 12, 2020 11:33 am The 4 macro buttons under a normal TAB. Not just under your Modern UI tab.

I dont think it's a good idea. Why we need a tab for just 4 option?