请问怎么在FC里测量一段曲线的长度?
Moderator: paullee
Forum rules
论坛规矩 / 論壇規矩 , 有用的资讯 / 有用的資訊
论坛规矩 / 論壇規矩 , 有用的资讯 / 有用的資訊
Re: 请问怎么在FC里测量一段曲线的长度?
再补充一问,如何测量曲线上任意两点之间沿曲线的距离?
Re: 请问怎么在FC里测量一段曲线的长度?
You first install an addon named "Curves". Then,
1. in viewport, select curve you want to measure
2. In Curves toolbar, click "Info" tool. The length of curve and other info is displayed on topleft corner of viewport.
Curves Workbench
https://github.com/tomate44/CurvesWB
- Attachments
-
- fsc_2020-05-11_142459b.jpg (123.34 KiB) Viewed 22146 times
Last edited by fc_tofu on Mon May 11, 2020 3:54 pm, edited 1 time in total.
Re: 请问怎么在FC里测量一段曲线的长度?
1. DraftWB, toggle on Snap bar >Near.
2. DraftWB >Line, draw a line between 2 arbitary points on your curve.
3. DraftWB >Trim, extend above line both ends beyond the curve.
4. PartWB, select both above line and curve, "Boolean Fragments", create a fragmented compound.
5. DraftWB >Downgrade, convert above compound into separate edges.
6. CurveWB >Join, combine needed edges into single curve.
7. CurveWB >Info, select above single curve in viewport.
- Attachments
-
- length_of_curve_segment.FCStd
- (15.62 KiB) Downloaded 629 times
Last edited by fc_tofu on Mon May 11, 2020 3:53 pm, edited 2 times in total.
Re: 请问怎么在FC里测量一段曲线的长度?
"英文化"了
的確 比中文輸入快
的確 比中文輸入快
Re: 请问怎么在FC里测量一段曲线的长度?
谢谢!FC官网的0.19版有两个版本,之前我在QQ群里问win7 64位该下哪个,群友说是“FreeCAD_0.19.20996_x64_LP_12.1.2_PY3QT5-WinVS2015.7z
”这个,但是我看FreeCADweb.cn给出的0.19的win64位版,是那个win-conda版的,不知道这两个版本有什么区别?