OS: Arch Linux (GNOME/gnome-xorg)
Word size of OS: 64-bit
Word size of FreeCAD: 64-bit
Version: 0.19.20052 (Git) AppImage
Build type: Release
Python version: 3.8.2
Qt version: 5.12.5
Coin version: 4.0.0
OCC version: 7.4.0
Locale: Russian/Russia (ru_RU)
When performing pocket pattern sparal does not cover the entire area.
And when you try to trim corners, it turns out to be just delusional - reproduced even in the simplest models. Perhaps the trick is to not parallelize the axes.
Here's the place for discussion related to CAM/CNC and the development of the Path module.
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 1 guest