Calculus error results from the workflow order?
Posted: Thu Oct 17, 2019 10:57 pm
Hello Fem Forum,
This week was my first introduction to the FEM WB. Quite impressive! I had one issue that I could solve myself. I made a suggestion about the wiki's / tutorials: https://forum.freecadweb.org/viewtopic.php?f=3&t=40173
One strange experience I should like to share:
The order of defining things does matter. E.g. if the mesh is created after the thicknesses have been applied to elements (I worked with meshes), Calculus gives an error. [or so it seems in my experience]. This is strange, because all items were properly branched under the treetrunk of the Analysis.
Can you reproduce this?
Such workflow order is not forced by the push buttons or the menu. Nor is it mentioned in the tutorials.
For your consideration.
Best regards
Roland
This week was my first introduction to the FEM WB. Quite impressive! I had one issue that I could solve myself. I made a suggestion about the wiki's / tutorials: https://forum.freecadweb.org/viewtopic.php?f=3&t=40173
One strange experience I should like to share:
The order of defining things does matter. E.g. if the mesh is created after the thicknesses have been applied to elements (I worked with meshes), Calculus gives an error. [or so it seems in my experience]. This is strange, because all items were properly branched under the treetrunk of the Analysis.
Can you reproduce this?
Such workflow order is not forced by the push buttons or the menu. Nor is it mentioned in the tutorials.
For your consideration.
Best regards
Roland