About the development of the FEM module/workbench.
- Posts: 10
- Joined: Tue Oct 22, 2019 9:02 am
spiderc3 wrote: ↑
Mon Nov 25, 2019 9:08 pm
@Jckcdt: Same problem or do You have a different outcome?
Even if it's not related to the problem presented in the topic, I had to deal with this one too. For my experience, when you see these green dots, its in fact a matter of jacobian and mesh refinement.
- Posts: 7
- Joined: Mon Nov 25, 2019 6:35 pm
Hello Bernd, hello Jckcdt,
thank You for Your reply and the kind offer to have a look at the geometry. You are right, the mesh was not good. An extruded mesh worked a lot better and the results are faster!
Thank You again!
- ExtrudedQuadMesh.PNG (236.72 KiB) Viewed 56 times
Freecad Version 0.18
- Posts: 8959
- Joined: Sun Sep 08, 2013 8:07 pm
- Location: Zürich, Switzerland
how did you create this quad mesh?
Who is online
Users browsing this forum: No registered users and 4 guests