Hi,
This Nastran-95 project is a slot in the middle of a plate pulled on both top and bottom ends. Only 1/4 is modeled. After solving, tried using Link actions to copy a mesh and result, then rotate it or mirror it to form the whole plate.
Looks fantastic.
Cheers,
John
Original 1/4 model
Original 1/4 result could be seen here
https://forum.freecadweb.org/viewtopic. ... 81#p438781
Combined full model by Link actions
Combined full result
Use Link actions to make a copy of a mesh and the result
Moderator: bernd
Forum rules
and Helpful information for the FEM forum
and Helpful information for the FEM forum