Expression for the Radius in the Part Fillet

[REl]

Hi,
I tried to use Expression for the Radius in the Part Fillet in the Part-WB. But it was not possible.

How and where can I check if someone set that on a wish list. Or how can I set it on a wish list.

[chrisb]

This is not about PartDesign module development so I moved it to Open discussion, that's where feature requests are discussed. You can check in the Bugtracker if such a request already exists.

You did very well in searching first and then discussing here in the forum before creating an official feature request in the tracker.